Operating your sound system - DAB+
1.Fully extend the telescopic aerial. If your sound system is in standby mode, press the On / Standby button to switch it on.
2.Press and release the Radio button to select DAB+ mode. The display will show “DAB” for a few seconds.
3.If this is the first time the sound system is used a quick scan of the DAB+ channels may be carried out (depending on whether scanning was already completed in standby mode). If the radio has been used before, the last used station will be selected.
4.When first switched on, the first station in the list of stations will
be shown. Press and release the Select button to tune to this station or press the Tuning Up or Down buttons to select an alternative station. See selecting a station on the following page. The display will show the station name on the upper line of the text display and broadcast information on the lower line.
5.If the station list is still empty after the scan operation or if the selected station cannot be received your radio will display “Service not available”.
6.If no signals are found it may be necessary to relocate your sound system to a position giving better reception, and then repeat the scan using the
Note that radio station name and frequency displays shown in this user guide may differ from those that you see on your radio. Broadcasters may change radio station names that are transmitted, and the frequencies used for DAB+ and FM radio stations may not be the same in all parts of the country.
10