Apple 3400C/200, G3 manual Replacement Notes

Take Apart		Display Cable - 108
Replacement Notes:		To ensure that the display is
properly seated, reassemble it in the following sequence,
noting the precautions.
•	Check that the display shield’s grounding tabs for the
•	microphone and the clutches are properly seated.
	Install the microphone and attach its connector.
•	Install the display cable onto its 2 pins and slide it onto
	the alignment guide.

• Wrap the display cable around the clutch and seat its grounding tab on the end of the clutch.

• Reattach the kapton tape to the “Y” section of the display cable.

• To prevent damage to the components on the display, lift

the bezel up slightly to reduce the load on the display. Then connect the display cable to the display.

• Attach 4 pieces of new kapton tape where indicated by the guide lines on the display shield.