Applica LM680 manual Setup Instructions, No Tools Required for Setup, Installing carbon filter

Accessories

5

4

1

3

Setup Instructions

No Tools Required for Setup

• Unpack the pieces of the unit: LitterMaid® litter box, AC adapter (packed in paper pulp), disposable waste receptacles, LitterMaid® scoop and rake cleaner, use and care book and cleaning brush (packed with disposable waste receptacles), plus any optional items including the carbon filters, paw-cleaning ramp and litter box carpet.

• Cut and remove the restraints on each end of the rake. Peel off the protective tape on the waste receptacle compartment cover and the battery compartment. Remove the styrofoam on top of the rake.

Note: Battery compartment takes 8 "AA" cell batteries. (Batteries not included).

Important: Do not mix old and new batteries. Do not mix alkaline and carbon-zinc (standard) batteries. Do not use rechargeable type (Ni-Cad, Ni- MH or Li-lon) batteries.

• Place a disposable waste receptacle under the waste receptacle compartment cover. Make sure that the front of the waste receptacle is under the five tabs (Fig.‑1). There should be no gap between unit and the waste receptacle. Attach waste receptacle lid by inserting pushtabs into the round holes. To secure, press on positions indicated (Fig. 2).

† 1. AC adapter (Part# LM680-05)) 2

†2. LitterMaid® scoop and rake cleaner (Part# LM680-06)

†3. Paw cleaning ramp (Part# LM680-07)

†4. Carbon Filters (8 included) (Part# LMF200)) (12 pk.)

†5. Disposable waste receptacle (8 included)

(12 pk.) (Part# LMR200)

(18 pk.) (Part# LMR300)

Note: † Indicates consumer replaceable/removable parts

	MAX
	MIN
Fig. 1	Fig. 2

Fig. 3

HOW THE LITTERMAID® SELF-CLEANING LITTER BOX WORKS

• Cat enters the unit; once he/she leaves, the sensors are triggered, setting the timer for the cleaning cycle. (Sensors need to be blocked for at least

5 seconds.)

Important: Unit will not start a cleaning cycle while cat is in the box.

• After 10 minutes, the cleaning cycle starts and the rake scoops out waste clumps.

• If the cat re-enters and leaves the litter box before the initial 10 minutes have elapsed, the rake will stop, the timer will automatically reset and delay the beginning of the cleaning cycle for an additional 10 minutes.

Note: Rake will stop and reverse if the safety bar touches any object that has gotten behind the rake while it is returning to its home position.

•Rake opens waste receptacle compartment cover and deposits clumps into the waste receptacle.

•Sealed disposable waste receptacle allows for safe and easy disposal of waste when full.

3

Installing carbon filter

•Peel off paper strip on the carbon filter to expose the adhesive. Place filter adhesive-side down in diamond-shaped insert in center of waste receptacle lid (Fig. 3). Close waste receptacle compartment cover.

•Use only hard clumping litter. Do not use non-clumping litter, crystal or pearl- like litters. Fill LitterMaid® litter box to just below the "Max Line". Do not overfill unit or it will not operate properly. Use the fill line on the LitterMaid® scoop and rake cleaner to check that litter is at the correct level incenter of unit (Fig. 4).

▼ Max Line ▼

Fig. 4

4