Applica LME5500MR manual Assembly

Assembly

1. Slide receptacle supports (marked L (left) and R (right)) into grooves on the bottom tray until they lock into place (A).

A

2. Place both left and right flaps flat on top of the waste receptacle compartment panel.

3. Push the flaps in and up until they click into place (B).

B

4. Lift the flaps until they lock into place (C).

C

5.Snap each pivot of the waste receptacle compartment cover, one at a time, into notches in the receptacle supports (D).

6. Open waste receptacle compartment cover.

H

J

K

•Attach the waste receptacle lid by inserting the push tabs into the round holes. To secure, press on positions indicated

(H).

Make sure lid edges are under the cover tabs (J).

9.Install carbon filter.

•Peel off the paper strip on the carbon filter to expose the adhesive.

•Place filter adhesive-side down in the diamond-shaped insert in the center of the waste receptacle lid (K). Close the waste receptacle compartment cover.

10.Fill the LitterMaid® litter box with litter to just below the Full Line marked inside of litter tray

	Important: Waste receptacle compartment cover must be
D	opened to remove and install top housing.

	7. Lift top housing. Angle into position bracket end of top
	housing under tray ledge. Important: 5 black tabs of the tray
	should be on top of the grey bar in front of the top housing
	(E). Bring the other end of top housing down so that it
	snaps into place. Check to be sure top housing is positioned
E	securely on the tray. If positioned correctly, you will not be
	able to read writing on silver tray ledge.

Important: Use only hard clumping litter. Do not use non-clumping litter, crystal or pearl-like litters.

Recommended Hard Clumping Liters

•LitterMaid™ Hard Clumping Cat Litter

•World's Best Cat Litter™

•ARM & HAMMER® Super Scoop® The Baking Soda Clumping Litter

•Fresh Step® Scoopable Premium Cat Litter

•EVER CLEAN® Premium Clumping Litter

Do not overfill the unit or it will not operate properly.

F

8.Insert waste receptacles.

•Open waste receptacle compartment cover.

•Insert a disposable waste receptacle into the waste receptacle compartment.

•Insert the edge of the waste receptacle in an inclined position and place it between the edge of the tray and the bar of the top housing (F).

• Use the Fill Line on the LitterMaid® triple-action tool

to check that the litter is at the correct level in the center

of the unit (L).

L

The LitterMaid® Triple-Action Tool

•Press the waste receptacle down into position (G).

•There should be no gap between the unit and the waste receptacle.

G

7

This handy 3-way tool helps you:

• Measure the level of litter (M).

M

8