Setup & Testing
System test mode
The system test mode is used to test a system after installation.. The outputs of the thermostat can be manually activated one at a time to test their function. The following instructions show how to enter the test mode and turn outputs on and off. The charts on the following pages show the output status for each test step for Heat/Cool and Heat Pump mode..
The test steps are:
Test Number | Heat/Cool | Heat Pump |
|
|
|
50 | Heating (W) (W2) | Aux Heating (W) (W2) |
|
|
|
51 | Cooling (Y) (Y2) | Compressor Cooling (Y) (Y2) |
|
|
|
52 | Fan (G) | Compressor Heating (Y) (Y2) |
|
|
|
53 |
| Fan (G) |
|
|
|
Setup & Testing
System test mode (continued)
How to enter the system test menu
Press | repeatedly until system is set to OFF.. | ||
Press and hold | and | for three seconds.. |
The screen of the first test step #50 is displayed:
SYSTEM TEST | FLASHES IF 24VAC | |
IS NOT PRESENT | ||
NUMBER | ||
| ||
| MODE (SW1 SETTING) | |
OUTPUT STATUS |
|
Press to turn on the output (01).. For multi stage
output, press again to turn on the 2nd stage (02)..
Press to turn off the output (00)..
Press to change to the next test step.
Press after the last test step. “DONE” will be displayed..
The thermostat will return to Normal mode if no button is pressed in 3 seconds..
14 | 15 |