APW Wyott GHPS-4H General Installation Instructions, Sides, Rear, Floor, 96”.141912.000.137

Models: GHP-4H GHPS-4H GHPS-6H GHP-6H GHPW-2H GHPS-2H

1 12
Download 12 pages 39 Kb
Page 4
Image 4
2. GENERAL INSTALLATION INSTRUCTIONS:

concealed, a claim must be made with the delivering carrier.

A)Apparent damage or loss must be noted on the freight bill at the time of delivery. It must then be signed by the carrier representative (Driver). If this is not done, the carrier may refuse the claim. The carrier can supply the necessary forms.

B)Concealed damage or loss if not apparent until after equipment is uncrated, a request for inspection must be made to the carrier within 15 days. The carrier should arrange an inspection. Be certain to hold all contents and packaging material.

Installation and start-up should be performed by a qualified installer who thoroughly read, understands and follows these instruction.

If you have questions concerning the installation, operation, maintenance or service of this product, write Technical Service Department APW Wyott Foodservice Equipment Company, P.O. Box 1829, Cheyenne, WY 82003.

2. GENERAL INSTALLATION INSTRUCTIONS:

Ensure gas supply and gas type, as shown on unit data plate agree. (Data plate is located on the right side panel of unit).

Unit installation must conform with the National Fuel Gas Code, ANSI Z223.1-1996, the National Gas Installation ode, CAN/CGA-B149.1, or the Propane Installation Code, CAN/CGA-B149.2 as applicable and in accordance with local codes.

Screw legs into the perm nently faste

ed nuts on the four corners of the unit and tighten by hand. Level the

unit by turning the adjustment scr w

t the bottom of each leg. Do not slide unit with legs mounted, lift if

necessary to move unit.

 

 

Pipe gas supply to unit.

 

 

Pipe threading compound must be resistant to the action of liquefied petroleum gases.

 

These units are suitable for installation

c mbustible and noncombustible surfaces.

 

 

 

 

!

Warning: DO NOT use an open flame to check for leaks. Check all gas piping for leaks

!

with a soap and water solu

before operating unit.

TheseunitsNONNON-COMBUSTABLE-aresuitableforsurfacesinstallationonly3..onSPECIFICATIONS

CLEARANCES

Sides

 

 

Rear

Floor

0”13.62631.141.637.144

 

 

 

 

96”.141912.000.137

4”

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

4

4.3488.035

 

111828..049500.754

 

613..241.825846

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Page 4
Image 4
APW Wyott GHPS-4H General Installation Instructions, Sides, Rear, Floor, 96”.141912.000.137, 0”13.62631.141.637.144