Arcam A70 Service information, Technical specifications, Sound cuts out unexpectedly, Inputs

Models: A70

1 12
Download 12 pages 37.32 Kb
Page 11
Image 11
Service information

Service information

Sound cuts out unexpectedly

Before returning an amplifier for repair, please check the following:

Heatsink protection

If the temperature of the internal heatsink rises above a safe level, a thermal cutout inside the amplifier operates, the power indicator on the front panel flashes and the protection system temporarily removes power to the speakers. The system resets after the heatsink has cooled down. Note that because of the high output voltage from a CD player, it is possible to drive the A70 at full power even though the volume is not set at maximum.

Transformer protection

The transformer is separately protected against thermal overload damage which may occur in exceptional circumstances. If the unit shuts down in this way, there is no indicator warning on the front panel: we recommend you disconnect the power supply and wait 30 minutes for the amplifier to completely cool. Power on in the normal way and the A70 will work normally.

Amplifier does not switch back on

The A70 and P90 amplifiers have a protection mechanism which is activated if you switch the unit on immediately after turning it off. If this mechanism activates, wait 30 seconds before switching back on again.

Technical specifications

English

Continuous power output, per channel

Both channels, 8Ω, 20Hz–20kHz

50W

Distortion, 8Ω, 80% power, 1kHz

0.005%

Inputs

 

Phono cartridge input sensitivity, MM

2.7mV

Line and tape inputs:

 

Nominal sensitivity

250mV

Input impedance

22kΩ

Signal/noise ratio (CCIR)

98dB

Preamplifier outputs

 

Nominal output level

545mV

Output impedance

<50Ω

General

 

Power consumption (maximum)

450VA

Dimensions W x D x H (including feet)

430 x 330 x 85mm

Weight (net)

7.5kg

Weight (packed)

9.5kg

Supplied accessories

mains lead

 

CR-389 remote control

 

2 x AAA batteries

E&OE

 

Continual improvement policy

Arcam has a policy of continual improvement for its products. This means that designs and specifications are subject to change without notice.

NOTE: All specification values are typical unless otherwise stated.

A70

E-11
Page 11
Image 11
Arcam A70 Service information, Technical specifications, Sound cuts out unexpectedly, Heatsink protection, Inputs, General