Using your C30 pre-amplifier
C30
ENTER
MODE RECORD SELECT
PHONO/AUX CD | TUNER | AV | DVD | VCR | TAPE | TONE | MUTE DISPLAY | PHONES | POWER | |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
FRONT PANEL CONTROLS
This section describes how to operate your amplifier.
If your amplifier has not been installed for you, you should first read the section ‘Installation: C30
POWER bn
Switches the unit on and off.
The power indicator light (directly above the switch) shows the status of the amplifier. A red light means the amplifier is in
Remote control receiver 1
The remote control’s infrared receiver is positioned behind the ‘FMJ’ badge. Ensure the receiver is in a clear line of sight from the remote control to allow signals to be received.
MODE 2, UP and DOWN 5
These buttons are intended for use with any future optional modules that may become available for the C30. The UP and DOWN buttons, however, are used with the existing C30
Control knob 7, SELECT 4 and ENTER 6
The control knob has two functions:
as a volume control, to adjust the output of the headphones and of the
when used in conjunction with the SELECT and ENTER buttons, to customise amplifier settings (see page 9).
VOLUME CONTROL SETTINGS
It is important to realise that volume level shown on the display is not an accurate indication of the power delivered to your loudspeakers.The amplifier often delivers its full power long before the volume control reaches its maximum position, particularly when listening to heavily recorded compact discs. However the amplifier also has to be capable of giving full power output from much lower level sources, such as tuners and cassette decks. Using these sources, the volume control setting may be much higher before distortion (audible overload) sets in.
It is possible to compensate for these input level differences by using the ‘Input trims’ menu item. See page 9 for further details on how to do this. Adjusting the input levels of each source individually will help to avoid accidental overload.
Source selectors 8
These buttons select the source connected to the corresponding input. A light above the relevant button indicates which input is currently selected and it will also usually be shown on the display. See page 6 for more information on connecting audio sources to the C30.
TONE 9
Switches the tone circuits on and off, including settings for individual sources. Note that the tone LED does not light unless a tone setting has been made. See page 9 for further information on the tone controls.
MUTE bk Silences all main analogue outputs when selected.
DISPLAY bl This switches the display brightness between Off/ Dim/Bright. This is provided to set the display brightness to a level that is comfortable for you. Switching the display off may give a small improvement in sound quality.
PHONES bm
This
The headphone socket is always active.To avoid possible damage, always disconnect headphones prior to switching the amplifier on or off.
6