Configuring your A38 amplifier
A38 setup
Adjusting listening settings
The A38 allows you to customise various features of the amplifier to fit your system. Use this diagram to help you navigate through the available configuration options.
In the diagram, the control knob is shown as .
Normally, the display shows the current volume and the control knob is used to adjust this.
Press menu once to enter the setup menu, then press OK repeatedly to cycle through the menu items. When
you have found the setting that you wish to adjust (as shown on the front panel display), you can change the setting using the control knob. Press MENU to store the change and return to volume display mode – or press OK again to move to the next setting.
Note that the menu will
The following items can be adjusted from the setup menu:
‘Power On’ state
English
Balance |
| This allows you to adjust the output balance between left and right channels. The display is | |
|
|
| also available directly by pressing the front panel Display button. |
Volume | resolution | There are three | |
|
|
| Standard and Fine represent different levels of |
|
|
| setting gives absolute increments in 0.5dB steps. |
Input | trims | Input trims are used to compensate for variations in output levels of different source | |
|
|
| equipment. If, for example, your CD player is louder at a given volume display value |
|
|
| than other inputs, you can attenuate it by using this setting so that it matches your other |
|
|
| components. |
|
|
| Use the |
|
|
| to set (increase or decrease) the input volume for that source. |
Max | on | volume | This can be used to limit the maximum volume the amplifier operates at when it is first |
|
|
| switched on: the A38 comes on at the (reduced) ‘Max. On Volume’ level if the |
|
|
| volume exceeds this value. |
|
|
| If this item is set to ‘Disabled’, the A38 always comes on at the last used volume, even if this |
|
|
| is very loud. |
Processor mode | Processor mode enables you to fix the gain (volume setting) of your A38. The A38 (in | ||
|
|
| combination with a power amp.) can then be used to drive the front left and right speakers |
|
|
| of a |
|
|
| system can then be controlled using the processor. |
|
|
| Feed the sound from the processor into the AV input, then set the gain of the A38 to match |
|
|
| the amplifiers that drive your other loudspeakers. |
Reset |
| Confirming ‘Yes’ restores all amplifier settings to their factory defaults. |