installation
Arcam’s T32 provides
As part of an Arcam system, the high performance T32 tuner is designed to truly bring your music and sound to life.
Placing the unit
<Place the T32 on a level, firm surface, avoiding direct sunlight and sources of heat or damp.
<Do not place the T32 on top of an amplifier or other source of heat.
<Do not place the T32 in an enclosed space such as a bookcase or closed cabinet unless there is good provision for ventilation. The T32 is designed to run warm during normal operation.
<Do not place any other component or item on top of the T32 as this may obstruct airflow around the unit, causing the T32 to run hot.
<Make sure the
<Do not place your record deck on top of this unit. Record decks are very sensitive to the noise generated by mains power supplies which will be heard as a background ‘hum’ if the record deck is too close.
Power
The T32 is supplied with a moulded mains plug already fitted to the lead. Check that the plug supplied fits your supply – should you require a new mains lead, please contact your Arcam dealer.
If your mains supply voltage or mains plug is different, please contact your Arcam dealer immediately
Push the IEC plug end of the power cable into the socket on the back of the T32, making sure that it is pushed in firmly. Plug the other end of the cable into your mains socket and, if necessary, switch the socket on.
Remote control input
The REMOTE IN input can be used to pass RC5 codes to the T32 if it is installed in a position, or a system, where infrared cannot be used. If this is required, please contact your dealer for further information.
In normal use there is no need to make any connections to this input.
The REMOTE IN input requires a mono 3.5mm jack, with the tip active and the sleeve grounded.
The remote control signals must be in modulated RC5 format (at 36kHz), with a voltage level of between 5V and 12V.
Interconnect cables
We recommend the use of
It is good practice when connecting your equipment to make sure that the mains