SPEED CONTROL BELL CRANK (self-propelled units)
The speed control bell crank holds the speed control rod in position after a speed has been set. The spring washers may become loose with normal wear. If the speed control rod does not stay firmly in position, adjust the speed control bell crank. See Figure 12.
To adjust:
1.Remove cover, fully compress the helical spring lock washers with lock nut and then back lock nut off, one quarter turn.
2.If the speed control rod is still too loose, tighten lock nut by small increments until it holds its position. Tightening the lock nut too much will not allow the speed control rod to move at all.
3.Align notch in left hand side of cover with bolt and secure with knob.
1
2
4
|
| 3 |
5 |
| 6 |
|
| |
|
| OM0300 |
1. Lock Nut | 3. | Speed |
2. Helical Spring |
| Control Bell |
Lock |
| Crank |
Washers | 4. | Speed |
|
| Control Rod |
| 5. | Hair Pin |
Figure 12
STORAGE
CAUTION: AVOID INJURY. Read and understand the entire Safety section before proceeding.
IMPORTANT: NEVER spray unit with water or store unit outdoors. Store mower in a cool, dry, protected location.
Cleaning
Clean unit thoroughly. Brush off dirt and debris from all surfaces.
Inspection
Inspect mower and repair or replace worn or damaged parts to avoid delays when beginning use again.
Regularly check all hardware and keep fasteners tight. Know unit is in safe working condition.
Grass Bag
Wash out grass bag and allow to dry before storage. Grass bag may be stored in position on mower.
Engine
When storing unit for extended periods of time, remove all fuel from tank and carburetor (run dry). Refer to engine manual.
GB - 18