Replace worn-out mufflers immediately. Continued use could result in fire or explosion.

Sharp edges can cut or amputate fingers or a hand. Wrap blade or wear sturdy gloves to service.

Use only replacement parts designed for your unit. See your Ariens Dealer.Allow engine to cool before storing in any enclosure.

ALWAYS clean unit before extended storage. See engine manual for proper storage.

DO NOT store unit inside a building with fuel in the fuel tank where any ignition sources are present.

Use only accessories which have been approved by Ariens and are properly installed.

Check attachments frequently and replace worn or damaged components with manufacturer’s recommended parts.

ASSEMBLY

CAUTION: AAVOID INJURY. Read and understand the entire Safety section before proceeding.

CARTON CONTENTS

1

2

3

 

OM0340

 

5

OM0320

OM1222

OM0350

1.

Mower Unit

4

2.

Side Discharge Deflector

3.

Grass Bag

 

4.

Grass Bag Frame

 

5.

Literature Pack

 

OM0330

Figure 4

ASSEMBLY

1.Unfold and adjust handlebar. See Service and Adjustments.

2.Self-Propelled Models: The speed control rod is shipped on the handlebar with hardware in position. Remove hair pin, insert bent end of rod through hole in swivel of speed control bell crank, and retain with hair pin (Figure 5).

3.Fill engine crankcase with oil. See engine manual.4.Assemble grass bag onto bag frame.

5.Set-up mower for bagging, side discharge or mulching. See Mower Set- Up in Operation Section.

6.Fill fuel tank. See Operation Section.

7.Check the engine/blade control feature. Try starting the engine without the engine/blade control held against the handlebar. Engine must not start. If engine starts, stop engine and adjust or repair engine/blade control. See Service and Adjustments.

GB - 9