Ariens 03883300A, 920400, 920401 ASSEMBLY

GB - 8

PACKAGE CONTENTS

ASSEMBLY

Tools Required:

• Pliers

• Open-end wrenches: 3/8, 7/16, 1/2,

9/16in. and/or adjus table wrench

• Tire gauge

Unfold Handlebar (Figure4)

1.Remove the lower and loosen the upper

hardware on the handlebar assembly.

2.Loosen the hard ware on the shift rod.

3.Put the speed selector lever in the sixth

forward position.

4.Rotate the handlebars into operating

position.

NOTE: Be careful not to damage cable spring

hooks when rotating handlebars upward.

5.Install and tighten the hardware on the

handlebar assembly and shift rod.

ASSEMBLY

WARNING: AVOID INJURY. Read

and understand the entire Safety

section before proceeding.

WARNING: Dropping or tipping over

boxed unit could result in personal

injury or damage to unit.

Figure3

1. Sno-Tek™ Unit

2. Discharge

Chute

3. Chute Crank

4. Literature Pack

with Extra

Shear Bolts

OS8261

Figure4 OS8025

1. Shift Rod

2. Upper and Lower Handlebar

Hardware

3. Shift Rod Hardware

4. Handlebar

Contents

Main Owner/Operator Manual Sno-T ek NON-ENGLISH MANUALS MANUALES EN IDIOMAS DIFERENTES DEL INGLES MANUELS NON ANGLAIS MANUALS TABLE OF CONTENTS INTRODUCTION PRODUCT REGISTRATION UNAUTHORIZED REPLACEMENT PARTS DISCLAIMER DELIVERY SAFETY ALERTS SAFETY 3 1. WARNING! 2. DANGER! 3. DANGER! SAFETY RULES Page Page PACKAGE CONTENTS ASSEMBLY Tools Required: Unfold Handlebar (Figure4) ASSEMBLY Install Discharge Chute (Figure5) Install Discharge Chute Crank (Figure6) Check Function of Dual Handle Interlock Check Tire Pressure Check Auger Gearcase Oil Check Engine Crankcase Oil Fill Engine Fuel Tank CONTROLS AND FEATURES CONTROLS AND FEATURES Dual Handle Interlock 1261 Traction Drive Clutch - Left Hand Lever OPERATION Fuel Shut-Off Valve Choke Control Recoil Starter Handle Snow Clean-Out Tool (Figure9) Discharge Chute Deflector FILLING FUEL TANK GASOLINE Fuel Recommendations Adding a Fuel Stabilizer to Extend Fuel Storage Life To add fuel to fuel tank: PRE-START 1. Frozen Impeller 2. Check Function of Clutches 3. Check Dual Handle Interlock 4. Check Axle Lock Pins MAINTENANCE Service Position MAINTENANCE SCHEDULE * ** CHECK DUAL HANDLE INTERLOCK CHECK FASTENERS CHECK CLUTCH OPERATION CHECK CLUTCH SPRING SERVICE AND ADJUSTMENTS SHEAR BOLTS For Replacement: DISCHARGE CHUTE DEFLECTOR DISCHARGE CHUTE SPEED SELECTOR ATTACHMENT DRIVE BELT REPLACEMENT Remove Attachment Drive Belt Replace Attachment Drive Belt TRACTION DRIVE BELT REPLACEMENT ATTACHMENT CLUTCH/BRAKE Remove Attachment Cable Slack Check Attachment Idler Arm Roller Clearance Adjust the Attachment Clutch Cable Spring Extension Check Attachment Brake (Figure28) Check Belt Finger Clearance (Figure29) TRACTION DRIVE CLUTCH FRICTION DISC REPLACEMENT Remove Friction Disc (Figure31 and Figure32): SHORT TERM LONG TERM Fuel System STORAGE SERVICE PARTS ACCESSORIES TROUBLESHOOTING PROBLEM PROBABLE CAUSE CORRECTION Engine will not crank/start. Engine stops. Engine problems. Does not operate in Forward / Reverse. Small rubber beads collect in frame SPECIFICATIONS Sno-Tek Two-Year Limited Warran ty Service Parts and Accessories Warranty Exceptions, Limitations, Exclusions Customer Responsibilities Limitations Exclusions Items Not Covered by This Warranty Disclaimer LIMITATION OF REMEDY AND DAMAGES DISCLAIMER OF FURTHER WARRANTY