Lenovo RS210 manual DSA Preboot messages continued

Table 5. DSA Preboot messages (continued)

vFollow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

vSee Chapter 7, “Parts listing, RS210 Types 6531, 6532, 6533, and 6534,” on page 177 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU).

vIf an action step is preceded by “(Trained service technician only),” that step must be performed only by a Trained service technician.

vGo to the Lenovo support Web site at http://www.lenovo.com/support to check for technical information, hints, tips, and new device drivers or to submit a request for information.

Message
number	Component	Test	State	Description	Action
201-810-xxx	Memory	Memory Test	Aborted	Test stopped:	1.	Turn off and restart the system.
				unknown error
					2. Run the test again.
				code xxx
					3. Make sure that the DSA code is at the latest level.
				received in
				COMMONEXIT		For the latest level of DSA code, go to
				procedure.		http://www.lenovo.com/support.
					4. Make sure that the server firmware is at the latest
						level. The installed firmware level is shown in the
						DSA event log in the Firmware/VPD section for
						this component. For more information, see
						“Updating the firmware” on page 212.
					5. Run the test again.
					6. If the failure remains, go to the Lenovo Web site
						for more troubleshooting information at
						http://www.lenovo.com/support..
201-901-xxx	Memory	Memory Test	Failed	Test failure:	1.	Turn off the system and disconnect it from the
				single-bit error,
						power source.
				failing DIMM
					2.	Reseat DIMM z.
				z.
					3.	Reconnect the system to power and turn on the
						system.
					4.	Make sure that the DSA code is at the latest
						level. For the latest level of DSA code, go to
						http://www.lenovo.com/support.
					5.	Make sure that the server firmware is at the
						latest level. The installed firmware level is
						shown in the DSA event log in the
						Firmware/VPD section for this component. For
						more information, see “Updating the firmware”
						on page 212.
					6.	Run the test again.
					7.	Replace the failing DIMMs.
					8.	Re-enable all memory in the Setup utility (see
						“Using the Setup Utility” on page 200).
					9.	Run the test again.
					10.	Replace the failing DIMM.
					11. If the failure remains, go to the Lenovo Web site
						for more troubleshooting information at
						http://www.lenovo.com/support..

Chapter 4. Diagnostics 91