Lenovo RS210 manual Using the Boot Manager program, Configuring RAID controllers

Table 23. System board jumpers (continued)

Jumper number

Jumper name

Jumper setting

Notes:

1.If no jumper is present, the server responds as if the pins are set to 1 and 2.

2.Changing the position of the UEFI boot recovery jumper from pins 1 and 2 to pins 2 and 3 before the server is turned on alters which flash ROM page is loaded. Do not change the jumper pin position after the server is turned on. This can cause an unpredictable problem.

Using the Boot Manager program

The Boot Manager program is a built-in, menu-driven configuration utility program that you can use to temporarily redefine the first startup device without changing settings in the Setup Utility.

To use the Boot Manager program, do the following:

1.Turn off the server.

2.Restart the server.

3.When the prompt <F12> Select Boot Device is displayed, press F12. If a bootable USB mass storage device is installed, a submenu item (USB Key/Disk) is displayed.

4.Use the Up arrow and Down arrow keys to select an item from the Boot Selection Menu and press Enter. The server attempts to boot from the selected device.

The next time the server starts, it returns to the startup sequence that is set in the Setup Utility.

Configuring RAID controllers

The following table lists the various utilities available to configure RAID controllers before an operating system is installed.

Table 24. RAID configuration utilities

				Where to find more
RAID configuration utility	Description		Location	information
EasyStartup RAID	v	For use with all	EasyStartup DVD	“Using the EasyStartup
configuration utility		factory-supported RAID		DVD” on page 209
		controllers except
		ServeRAID-BR10i
	v	Automatically detects
		hardware and lists all
		supported RAID
		configurations
	v	Configures one or more
		disk arrays per controller
		depending on the number
		of drives attached to the
		controller and the RAID
		level selected
	v Supports hot-spare drives
	v Creates a RAID response
		file that can be used to
		configure RAID controllers
		on similarly configured
		Lenovo servers.

Chapter 8. Configuring the server 205