Lenovo RS210 manual Memory Logging Limit Reached for

vFollow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

vSee Chapter 7, “Parts listing, RS210 Types 6531, 6532, 6533, and 6534,” on page 177 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU).

vIf an action step is preceded by “(Trained service technician only),” that step must be performed only by a trained service technician.

Memory Logging Limit Reached for	Error	The memory logging limit	1.	Update the server firmware to
DIMM One of the DIMMs on		has been reached.
				the latest level.
Memory Subsystem One of the
				Important: Some cluster
DIMMs.
				solutions require specific code
				levels or coordinated code
				updates. If the device is part
				of a cluster solution, verify
				that the latest level of code is
				supported for the cluster
				solution before you update
				the code.
			2. Reseat the DIMMs and run
				the DSA memory test.
			3. Replace any DIMM that is
				indicated by a lit error LED.
Memory DIMM Configuration Error	Error	A DIMM configuration error	Make sure that DIMMs are
for One of the DIMMs on Memory		has occurred.	installed in the correct sequence
Subsystem One of the DIMMs.			and have the same size, type,
			speed, and technology.
Memory uncorrectable error detected	Error	A memory uncorrectable	1.	If the server failed the POST
for DIMM n Status on Memory		error has occurred.
				memory test, reseat the
Subsystem DIMM n Status.
				DIMMs.
(n = DIMM number)
			2. Replace any DIMM that is
				indicated by a lit error LED.
				Note: You do not have to
				replace DIMMs by pairs.
			3. Run the Setup utility to
				enable all the DIMMs.
			4. Run the DSA memory test.
			5.	(Trained service technician
				only) Replace the system
				board.
Memory Logging Limit Reached for	Error	The memory logging limit	1.	Update the server firmware to
DIMM nStatus on Memory		has been reached.
				the latest level.
Subsystem DIMMnStatus.
				Important: Some cluster
(n = DIMM number)
				solutions require specific code
				levels or coordinated code
				updates. If the device is part
				of a cluster solution, verify
				that the latest level of code is
				supported for the cluster
				solution before you update
				the code.
			2. Reseat the DIMMs and run
				the DSA memory test.
			3. Replace any DIMM that is
				indicated by a lit error LED.

Chapter 4. Diagnostics 39