Lenovo RS210 manual DSA Preboot messages continued

Table 5. DSA Preboot messages (continued)

vFollow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

vSee Chapter 7, “Parts listing, RS210 Types 6531, 6532, 6533, and 6534,” on page 177 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU).

vIf an action step is preceded by “(Trained service technician only),” that step must be performed only by a Trained service technician.

vGo to the Lenovo support Web site at http://www.lenovo.com/support to check for technical information, hints, tips, and new device drivers or to submit a request for information.

Message
number	Component	Test	State	Description	Action
166-802-xxx	IMM	IMM I2C Test	Aborted	IMM I2C test	1.	Turn off the system and disconnect it from the
				stopped: the
						power source. You must disconnect the system
				test cannot be
						from ac power to reset the IMM.
				completed for
					2.	After 45 seconds, reconnect the system to the
				an unknown
						power source and turn on the system.
				reason.
					3.	Run the test again.
					4.	Make sure that the DSA code is at the latest level.
						For the latest level of DSA code, go to
						http://www.lenovo.com/support.
					5.	Make sure that the IMM firmware is at the latest
						level. The installed firmware level is shown in the
						DSA event log in the Firmware/VPD section for
						this component. For more information, see
						“Updating the firmware” on page 212.
					6.	Run the test again.
					7.	If the failure remains, go to the Lenovo Web site
						for more troubleshooting information at
						http://www.lenovo.com/support..
166-803-xxx	IMM	IMM I2C Test	Aborted	IMM I2C test	1.	Turn off the system and disconnect it from the
				stopped: the
						power source. You must disconnect the system
				node is busy;
						from ac power to reset the IMM.
				try later.
					2.	After 45 seconds, reconnect the system to the
						power source and turn on the system.
					3.	Run the test again.
					4.	Make sure that the DSA code is at the latest level.
						For the latest level of DSA code, go to
						http://www.lenovo.com/support.
					5.	Make sure that the IMM firmware is at the latest
						level. The installed firmware level is shown in the
						DSA event log in the Firmware/VPD section for
						this component. For more information, see
						“Updating the firmware” on page 212.
					6.	Run the test again.
					7.	If the failure remains, go to the Lenovo Web site
						for more troubleshooting information at
						http://www.lenovo.com/support..

Chapter 4. Diagnostics 73