Lenovo RS210 manual DSA Preboot messages continued

Table 5. DSA Preboot messages (continued)

vFollow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

vSee Chapter 7, “Parts listing, RS210 Types 6531, 6532, 6533, and 6534,” on page 177 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU).

vIf an action step is preceded by “(Trained service technician only),” that step must be performed only by a Trained service technician.

vGo to the Lenovo support Web site at http://www.lenovo.com/support to check for technical information, hints, tips, and new device drivers or to submit a request for information.

Message
number	Component	Test	State	Description	Action
405-903-xxx	BroadCom	Test Internal	Failed		1. Make sure that the component firmware is at the
	Ethernet	Memory
					latest level. The installed firmware level is shown
	Device
					in the DSA event log in the Firmware/VPD
					section for this component. For more information,
					see “Updating the firmware” on page 212.
					2. Run the test again.
					3. Check the interrupt assignments in the PCI
					Hardware section of the DSA event log. If the
					Ethernet device is sharing interrupts, if possible,
					use the Setup utility see “Using the Setup Utility”
					on page 200) to assign a unique interrupt to the
					device.
					4. Replace the component that is causing the error. If
					the error is caused by an adapter, replace the
					adapter. Check the PCI Information and Network
					Settings information in the DSA event log to
					determine the physical location of the failing
					component.
					5. If the failure remains, go to the Lenovo Web site
					for more troubleshooting information at
					http://www.lenovo.com/support..
405-904-xxx	BroadCom	Test Interrupt	Failed		1. Make sure that the component firmware is at the
	Ethernet
					latest level. The installed firmware level is shown
	Device
					in the DSA event log in the Firmware/VPD
					section for this component. For more information,
					see “Updating the firmware” on page 212.
					2. Run the test again.
					3. Check the interrupt assignments in the PCI
					Hardware section of the DSA event log. If the
					Ethernet device is sharing interrupts, if possible,
					use the Setup utility see “Using the Setup Utility”
					on page 200) to assign a unique interrupt to the
					device.
					4. Replace the component that is causing the error. If
					the error is caused by an adapter, replace the
					adapter. Check the PCI Information and Network
					Settings information in the DSA event log to
					determine the physical location of the failing
					component.
					5. If the failure remains, go to the Lenovo Web site
					for more troubleshooting information at
					http://www.lenovo.com/support..

98ThinkServer ThinkServer RS210, Types 6531, 6532, 6533, and 6534: Hardware Maintenance Manual