Lenovo RS210 manual Installing a simple-swap Serial ATA SATA hard disk drive

2.Make sure that the server cover is in place and fully closed.

3.Turn off the server and peripheral devices, and disconnect the power cord and all external cables.

4.Remove the filler panel 2 from the bay.

5.Pull the loops of the drive tray toward each other and pull the tray 3 out of the bay.

Installing a simple-swap Serial ATA (SATA) hard disk drive

Attention: Simple-swap hard disk drives are not hot-swappable. Disconnect all power from the server before you remove or install a simple-swap hard disk drive.

To install a simple-swap SATA hard disk drive, complete the following steps.

Note: If your server has only one simple-swap hard disk drive, make sure it is installed in the left drive bay.

Attention: To avoid damage to the hard disk drive connectors, make sure that the server cover is in place and fully closed whenever you install or remove a hard disk drive.

1.Read the safety information in “Important Safety Information” on page 1 and “Guidelines for trained service technicians” on page 115.

2.Make sure that the server cover is in place and fully closed.

3.Turn off the server and peripheral devices, and disconnect the power cord and all external cables.

4.Remove the filler panel 2 from the bay if necessary.

5.Pull the loops of the drive tray toward each other, and slide the drive 3 into the server until the drive connects to the back plate 1.

Chapter 6. Replacing FRUs 127