Lenovo RS210 manual Error code, Description, Action

vFollow the suggested actions in the order in which they are listed in the Action column until the problem is solved.

vSee Chapter 7, “Parts listing, RS210 Types 6531, 6532, 6533, and 6534,” on page 177 to determine which components are customer replaceable units (CRU) and which components are field replaceable units (FRU).

vIf an action step is preceded by “(Trained service technician only),” that step must be performed only by a trained service technician.

vGo to the Lenovo support Web site at http://www.lenovo.com/support to check for technical information, hints, tips, and new device drivers or to submit a request for information.

Error code	Description	Action
0010002	Microprocessor not supported.	1.	(Trained service technician only) Reseat the
			microprocessor and restart the server.
		2.	(Trained service technician only) Remove the
			microprocessor and install a new microprocessor.
			Restart the server. If the error is corrected, the old
			microprocessor is bad and must be replaced.
		3.	Replace the following components one at a time,
			in the order shown, restarting the server each
			time.
			a. (Trained service technician only)
			Microprocessor
			b. (Trained service technician only) System board
0011000	Invalid microprocessor type.	1.	Update the server firmware to the latest level (see
			“Updating the firmware” on page 212).
		2.	(Trained service technician only) Remove and
			replace the affected microprocessor (error LED is
			lit) with a supported type (see “Installing the
			microprocessor” on page 141).
0011004	Microprocessor failed BIST.	1.	Update the server firmware to the latest level (see
			“Updating the firmware” on page 212).
		2.	(Trained service technician only) Reseat the
			microprocessor.
		3.	Replace the following components one at a time,
			in the order shown, restarting the server each
			time:
			a. (Trained service technician only)
			Microprocessor
			b. (Trained service technician only) System board
001100A	Microcode updated failed.	1.	Update the server firmware to the latest level (see
			“Updating the firmware” on page 212).
		2.	(Trained service technician only) Replace the
			microprocessor.
0050001	DIMM disabled.	1.	If the server fails the POST memory test, reseat
			the DIMMs.
		2.	Remove and replace any DIMM for which the
			associated error LED is lit (see “Removing a
			memory module” on page 124 and “Installing a
			memory module” on page 125).
		3.	Run the Setup utility to enable all the DIMMs.
		4.	Run the DSA Preboot memory test (see “Running
			the diagnostic programs” on page 69).

22ThinkServer ThinkServer RS210, Types 6531, 6532, 6533, and 6534: Hardware Maintenance Manual