Lenovo RS210 manual Installing the DVD drive cable

Models: RS210

1 244
Download 244 pages 35.96 Kb
Page 171
Image 171
Installing the DVD drive cable

7.Remove the cable from the DVD drive cage connector.

8.Disconnect the DVD drive power cable from the power supply cable.

9.If you are instructed to return the DVD drive cable, follow all packaging instructions, and use any packaging materials for shipping that are supplied to you.

Installing the DVD drive cable

To install the DVD drive cable, complete the following steps:

1.Read the safety information in “Important Safety Information” on page 1 and “Guidelines for trained service technicians” on page 115.

2.Turn off the server and peripheral devices and disconnect the power cords and all external cables.

3.Align the cable connector with the connector on the rear of the DVD drive cage and press the cable connector into the DVD drive cage connector until it is firmly seated.

4.Pull the cable connector latch 2 up and hold it there while you slide the cable connector to the lock position; then, slide the cable connector latch down to lock the cable in place.

The following illustration shows cable routing for the DVD drive cable.

Chapter 6. Replacing FRUs 163

Page 171
Image 171
Lenovo RS210 manual Installing the DVD drive cable