ASSEMBLY

Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness.

CONTENTS OF HARDWARE PACK

(2) Handle Locks

(1) Carriage Bolt

(1) Center Locknut

 

3/8-16 UNC x 1 Grade 5

3/8-16 UNC

(1) Flat Washer 13/32 x 1 x 11 Gauge

(1) Handle Lock Lever

(1) Hairpin Clip

(1) Pivot Bolt

 

3/8-16 UNC Grade 5

Extra Shear Pins & Clips

TOOLS REQUIRED FOR ASSEMBLY

A socket wrench set will make assembly easier. Standard wrench sizes are listed.

(1) Utility knife

(1)Tire pressure gauge

(1)Pair of pliers

UNPACKING CARTON (See Fig. 2)

CAUTION: Be careful of exposed staples when handling or disposing of cartoning material.

IMPORTANT: WHEN UNPACKING AND ASSEMBLING TILLER, BE CAREFUL NOT TO STRETCH OR KINK CABLES.

(1) 9/16" wrench

OPERATOR’S POSITION (See Fig. 1)

When right or left hand is mentioned in this manual, it means when you are in the operating position (standing behind tiller handles).

FRONT

LEFTRIGHT

OPERATOR’S

POSITION

Fig. 1

While holding handle assembly, cut cable ties securing handle assembly to top frame. Let handle assembly rest on tiller.

Remove top frame of carton.

Slowly ease handle assembly up and place on top of carton.

Cut down right hand front and right hand rear corners of carton. Lay side carton wall down.

Remove packing material from handle assembly.

SHIFT ROD

HANDLE

ASSEMBLY

Fig. 2

4