6
NA
Electrical
• Machine Voltage/Amperage - 120V, 60 Hz, 4 Amp.
• Connection - 3-prong plug with 6’ cord is provided with
the machine.
• Circuit/Protector - 3-wire single phase, 120V, 60 Hz, AC,
on a separate 15 Amp circuit.
Technical Information
Technical data
Model ARWXF 129 W
Dimensions
width: 23.4”” (59.5 cm)
height: 33.24”” - 33.75”” (84.5 - 85.7 cm)
depth: 22”” (55.9) cm
Weight 148 lbs
Minimum Installa-
tion Clearances
Sides: 0””
Front / Back: 1””
Capacity Washing: 2 to 15 lbs. (1 to 7 kg)
Electrical
connections Voltage: 120Volts, 4 A, 60 Hz
Water
connections
Max. Pressure: 0.69 MPa (6.9 bar), 100 psi
Min. Pressure: 0.05 MPa (0.5 bar), 7.2 psi
Max. Spin speed up to 1200 RPM
Indesit Company offers to his customers
products with the ENERGY STAR Label.
This appliance was tested by UL and
conforms with both Canadian and U.S.
UL safety requirements and displays
their Mark.
CULUS LISTED
®
• Insert the outlet end of the drain hose into the standpipe,
wall or floor drain (Fig. 6). NOTE: The outlet end of the
drain hose MUST be at least 20” (50 cm) above the base
of the machine. No more than 6” of the drain hose should
be inserted into the drain pipe to prevent siphoning.
• Use a strap, cable tie, or similar item to hold the hose or
the U-Clamp in place.
Under Sink Method
1. Cut the blocked end of
the under sink drainage unit.
2. Fix the hooked end sup-
porta minimum of 620 mm
from the floor.
3. Use a hose clip clamp to
securely attach the grey drai-
nage hose end to the under
sink drainage unit using a
hose. clamp
20" (62 cm) min.
34" (86 cm) max.
Standpipe
"Y" Tail Piece
This connection MUST be
before drain trap and at
least 20" (50.8 cm) above
the floor where washer will
be installed.
Cable tie
Floor Standpipe w/ "Y" Branch Tail Piece
Fig. 7
20" (50 cm) min.
with an air break
25" (62 cm) min.
34" (86 cm) max.
6" max.
Standpipe
Floor Standpipe
Fig. 6
U-Clamp