Connections and Setup
How to Program the Remote
There are two ways to program the remote control: automatic code search and direct entry.
VCR1 ON•OFF MONITOR
DVD VCR2 AUX HD RCVR
Component Buttons
These are the buttons you program to operate another component.
Using Automatic Code Search
1.Turn on the component you want the emoter to operate (VCR, HD receiver, etc.)
2.Press and hold the component button that corresponds to the component you want the remote to operate (VCR, HD eceiver, etc.). While you hold down the component button, press and hold ON•OFF (when the red light on the remote turns on, release both buttons).
Note: Automatic Code Search can’t be used with the AUX button.
3.Press PLAY (the red light on the remote starts flashing).
The remote is searching the first set of component codes (ther are several sets of codes). If the component you want to operate doesn’t turn off automatically after 5 seconds, press PLAY again (the red light starts flashing again as the remote searches through the next set of codes).
Continue pressing PLAY until the component turns off.
NOTE: If the component doesn’t turn off after you’ve pressed the PLAY button 20 times, the component can’t be programmed.
4.Press REVERSE and wait 2 seconds. Repeat this step until the component turns back on.
5.To finish, press and hold the STOP button until the edr light on the remote turns off.
16 | Chapter 1 |