Installation instructions
NA | ! This instruction manual should be kept in a safe place | |
for future reference. If the washer is sold, transferred or | ||
| ||
| moved, make sure that the instruction manual remains with | |
| the machine so that the new owner is able to familiarise | |
| himself/herself with its operation and features. | |
| ! Read these instructions carefully: they contain vital infor- | |
| mation relating to the safe installation and operation of the | |
| appliance. | |
| Unpacking and levelling | |
| Unpacking | |
| 1. Remove the washer from its packaging. | |
| 2. Make sure that the washer has not been damaged | |
| during the transportation process. If it has been damaged, | |
| contact the retailer and do not proceed any further with the | |
| installation process. | |
| 3. Remove the 4 protective | |
| screws (used during tran- | |
| sportation) and the rubber | |
| washer with the correspon- | |
| ding spacer, located on the | |
| rear part of the appliance | |
| (see figure). |
4.Close off the holes using the plastic plugs provided.
5.Keep all the parts in a safe place: you will need them again if the washer needs to be moved to another location.
!Packaging materials should not be used as toys for children.
Levelling
1.Install the washer on a flat sturdy floor, without resting it up against walls, furniture cabinets or anything else.
2.If the floor is not perfectly level, compensate for any unevenness by tightening
or loosening the adjustable front feet (see figure); the an- gle of inclination, measured in relation to the worktop, must not exceed 2°.
Levelling the machine correctly will provide it with stability, help to avoid vibrations and excessive noise and prevent it from shifting while it is operating.
Minimum Installation Spacing
Recessed Front View
0" * |
|
|
|
|
|
|
| 0" * |
|
|
|
|
| Side View |
1" | 1" * |
This appliance may be installed in a recessed area, closet or alcove. The installation spacing is in inches and is the minimum acceptable.
*Additional spacing should be considered for easy instal- lation, servicing and compliance with local codes and ordinances. Installations must conform with the minimum dimensions indicated.
4
