Position slide bar assembly on the outside of the caster frame. Put a nylon washer on each 1 3/4 inch screw, insert screws through frame and slide bar assembly and add nylon washers and hex nuts. Tighten nuts using a screwdriver and pliers. Figure 19.
Notch to the front
Slide bar
View from front of barbecue
Figure 19
To lower table: Pull support rod up to disengage slide lock, and lower table. To raise table, lift table up and engage slide in locked position. Figure 20.
Support rod
View from rear of barbecue
Slide
Unlocked position | Locked position |
Figure 20
Step 16
Install right hand swing table
You will need: swing table end bracket, two
Allow the slide bar to hang down. Push the support rod into the lower support bracket. Figure 21 (a). Swing the rod up so you can slide the rod all the way inside the locking tab. Figure 21 (b). The rod should swing freely inside the locking tab. Figure 21 (c).
View from rear
(b) | (c) |
Support rod
(a)
Slide bar 
assembly
Figure 21
18
