EN

Troubleshooting

Before you call our Customer Care Department, go through the following troubleshooting suggestions:

Problem:

The dryer won’t start.

Possible causes / Solution:

The plug is not plugged into the socket, or not making contact.

There has been a power outage.

The fuse has blown. Try to plug another appliance into the socket.

You are using an extension cord? Try to plug the dryer’s power cord directly into the socket.

The door is not closed securely?

The PROGRAMS knob has not been set properly (see Start and Programs).

The START button has not been pressed (see Start and Programs).

Drying cycle will not begin.

Its taking a long time to dry.

You have set a delay time (see Start and Programs).

The filter has not been cleaned (see Maintenance).

The correct program has not been selected for the type of fabric you are drying (see Start and Programs).

The exhaust duct is obstructed (see Installation).

The air intake vent is obstructed (see Installation).

The permanent ventilation flap on the storm cover is obstructed (see Installation).

The items were too wet (see Laundry).

The dryer was overloaded (see Laundry).

Program finishes and clothes

! For safety the dryer has a maximum program time of 3 hours. If an

are damper than expected.

automatic program has not sensed the required final moisture in this time

 

the dryer will complete the program and stop. Check the above points and

 

run the program again, if the results are still damp, contact our Customer

 

Care Department.

The display shows a fault

Note down the code and contact the our Customer Care Department.

code F followed by one or two

 

numbers.

 

If you still have a problem, call our Customer Care Department at: 1-800-356-0766

10

Page 10
Image 10
Ariston ASL65VXS important safety instructions Troubleshooting, Problem, Possible causes / Solution