4 ARISTON DISHWASHER - User Manual

www.aristonappliances.us
How to load your dishes

First.

Before placing the dishes
in the racks, remove the
largest scraps of food left
over on your plates, you
will thus avoid blocking the
filter, which would reduce
the efficiency of the
wash.If the saucepans and
frying pans are very dirty,
allow them to soak before
being washed. To make it
easier to load your dishes,
pull the racks out.

What goes into the lower

rack?

We recommend you place
the most difficult dishes to
wash into the lower rack:
saucepans, lids, soup
bowls and plates (a load
example is shown in the
photo).
Serving dishes and large
lids: place them on the sides of
the rack.
Saucepans, salad bowls:
must always be placed upside
down
Very deep dishes: place them
obliquely, thus allowing water to
run down them and cleaning
them better
The cutlery basket can be
split up by pulling out the
handle.
When you only have little
cutlery to wash, you can
use just half the basket;
save space for other
crockery or place the other
half of the basket in the
upper rack instead (see
figures A and B).
This basket is equipped
with two removable grids:
insert the cutlery one by
one into the slots.
Warning:
knives and utensils
with sharp blades or tips
should be positioned with
the sharp parts at the
bottom.
Position all cutlery items so
that they don't touch.

What goes into the upper

rack?

Place delicate and
lightweight dishes in the
upper rack: glasses, tea
cups and coffee cups,
saucers - but plates too -
shallow salad bowls,
slightly dirty frying pans and
shallow pans (the photo
illustrates a few examples).
Position lightweight dishes
in such a way as to avoid
their being moved by the
spray of water.
After loading the dishes,
remember to check that the
blades on the sprayer arms
can turn freely without
knocking against any
dishes.

How to adjust the top rack.

The upper rack can be set
in high or low position to
enable you to organize
your dishes effortlessly.
lower rack upper rack
How to use our racks
Open the rail stop flaps and pull the rack
out completely. Now place it in high or low
position, then slide it along the guide rails
until the front wheels also go in. Now
close the rail stop flaps. Follow the
sequence of actions illustrated in figure
"F".