Operation

The visual indications are based on the assumption that the Pink wire (Indicators) and the Black/Red wires (LED) have been connected (See page 3).

The standard key fob has three buttons; Lock, Unlock and Silent.

To Arm the system.

Press the Lock button of the fob. The alarm will beep twice and flash the indicators twice. The system LED will start to flash after 5 seconds and the unit will monitor hot-wire, accessory switch, movement and nudge. (The system will not arm if the ignition is switched on).

To Disarm the system.

Press the Unlock button. The system will give one short beep and flash the indicators once.

NOTE If the system gives one long beep this means the alarm has been sounding. Enter diagnostics mode to find the reason why.

Convenience (Ferry) Mode

In Convenience mode the movement/nudge sensor will cease to function. With the alarm active, press the Silent button. You will get one long tone and one flash of the indicators.

If the LED flashes once/per second the movement sensing is active

If the LED flashes once every two seconds, the movement sensing is disabled.

You can ‘toggle’ between Convenience Mode enabled and disabled by simply pressing the silent button.

Diagnostics Mode

It is possible to determine the trigger source that caused the alarm to sound. Only the last reason is recorded.

Diagnostic mode can be accessed two ways;

a.When the alarm is sounding the LED will flash a number of times, pause, then flash the same number again. This will go 30 seconds until the system stops sounding.

b.Alternatively, disarm the alarm and then press the silent button. The LED will flash a number of times and the system will beep the same number of times. Every time you press the silent button the system will flash/beep in accordance with the following table.

Number of

Trigger Reason

Flashes/Beeps

 

 

 

1

No Triggers in last armed period

 

 

 

Power was interrupted (The SCOOTER does not have

2

an internal battery but if the power is disconnected

when the unit is armed, and then re-connected it will

 

 

give a reaction.)

3

Ignition turned on or hot-wired

 

 

4

Movement

 

 

5

Accessory switch was operated

 

 

4

Page 5
Image 5
Arkon 51020 Operation, Convenience Ferry Mode, Diagnostics Mode, An internal battery but if the power is disconnected