New Key Fob/Lost Key Fobs

If you can disarm the system - ie; you have a working fob and need to add another;

1.Switch ignition off

2.Disarm the system from the fob

3.NOTE Sections 4 and 5 must be completed within 10 seconds

4.Switch the ignition on-off 5 times in quick succession, leaving the ignition ON at the 5th action

5.Change the state of the accessory switch circuit - WHITE wire (ie; connect to ground if not connected and vice versa) The unit will beep once and enter learn mode

6.Press and hold the Lock button until the unit beeps then release it

7.The unit will beep twice

8.Press and hold the Lock button again and the unit will beep three times.

If the system is dis-armed but you don’t have a working fob (you have lost all working fobs);

1.Switch off the scooter ignition

2.Remove alarm fuse

3.Leave for 5 minutes

4.Reconnect alarm fuse (and within 10 seconds perform sections 5 & 6)

5.Switch the ignition on-off 5 times in quick succession, leaving the ignition ON at the 5th action

6.Change the state of the accessory switch circuit - WHITE wire (ie; connect to ground if not connected and vice versa) The unit will beep once and enter learn mode

7.Press and hold the Lock button until the unit beeps then release it

8.The unit will beep twice

9.Press and hold the Lock button again and the unit will beep three times

If the system is armed and you don’t have a working fob (you have lost all working fobs);

1.

Ensure the scooter ignition is switched off.

2.

Remove the alarm fuse

3.

Leave for 5 minutes

4.

Replace the alarm fuse - the alarm will sound

 

for 30 seconds (unless the system has sounded

 

10 times for power loss in which case there will

 

not be an audible reaction but wait 30 seconds)

 

Ensure the ignition is OFF during this time and

 

ensure the alarm is not triggered by accessory

 

switch or movement

5.

Trigger the alarm by turning ON the ignition.

 

When the alarm sounds turn the ignition OFF.

 

When the siren stops after 30 seconds (ie;

 

during the quiet time) you have 10 seconds to

 

perform steps 6 & 7

6.

Switch the ignition on and off 5 times, leaving

 

the ignition ON at the fifth action

7.

Change the state of the accessory switch

 

circuit - WHITE wire (ie; connect to ground if

 

not connected and vice versa) The unit will

 

beep once and enter learn mode

8.

Press and hold the Lock button until the unit beeps

 

then release it

NEW/REPLACEMENT/UPGRADED KEY FOBS CAN BE ORDERED

DIRECT FROM ACUMEN

www.acumen-electronics.co.uk

9.

The unit will beep twice

10.

Press and hold the Lock button again and the

 

unit will beep three times.

5

Page 6
Image 6
Arkon 51020 manual New Key Fob/Lost Key Fobs