USING=YOUR=WATER=KETTLE
Before=First=Use:
Before using for the first time, it is recommended to clean the interior of the kettle thoroughly. Please follow the procedure below before using the kettle:
1. Remove all packing materials and make sure that product is received in good condition.
2. Taking care to keep the electrical components on the exterior of the kettle dry, wipe out the interior of the kettle with a damp, soapy cloth. If your hand will not fit inside the kettle, swish warm, soapy water around in the interior of the kettle with the lid closed.
3. Rinse out the inside of the kettle thoroughly with water.
4. With a damp cloth, gently wipe off the exterior of the kettle. Do not wipe off electrical components. This may cause damage to the unit.
5. Dry all parts completely.
6. It is also recommended to run your kettle through one boiling cycle before using it to consume beverages. Following the instructions in the “Boiling Water” section below, boil one kettle of water. When water has boiled, pour it out and rinse the inside of the kettle once more. Your kettle is now ready for use.
BOILING=WATER:
1. Place power base on a sturdy, level
2. Remove the kettle lid and fill with water through lid opening. To remove the lid, press the lid release buttons on the lid and lift as shown in Figure A.
3. Fill the kettle with the appropriate amount of water.
Do not fill past the “MAX” line on the water level indicator. Never fill kettle with any liquid other than water.
HELPFUL HINT:
Use distilled water when possible for best taste and to minimize mineral
3.Close the lid until it locks securely into place.
4.Making sure the kettle and power base are completely dry and sitting on a level, sturdy and
5.Push up the power switch, located on the power base, to begin the boiling process. The indicator light will illuminate.
Figure A
CONTINUED ON NEXT PAGE | 5 |
