ArtDio IPS-3101h user manual User’s Manaul

User’s Manaul

Preferred

Vocoder

G723 Rate:

iLBC frame size:

iLBC payload type:

Silence

Suppression

Voice Frames per

TX

Layer 3 QoS

Layer 2 QoS

The BudgeTone IPS-3101h supports up to 6 different vocoder types including G.711 A-/U-law，G.723.1, G.726, G.728, G.729A/B, iLBC. Depending on the product model, some of these vocoders may not be provided in standard release.

A user can configure vocoders in a preference list that will be included with the same preference order in SDP message. The first vocoder in this list can be entered by choosing the appropriate option in “Choice 1”. Similarly, the last vocoder in this list can be entered by choosing the appropriate option in “Choice 6”.

This defines the encoding rate for G723 vocoder. By default, 6.3kbps rate is chose.

This sets the iLBC size in 20ms or 30ms

This defines payload time for iLBC. Default value is 98. The valid range is between 96 and 127.

This controls the silence suppression/VAD feature of G723 and G729. If set to “Yes”, when a silence is detected, small quantity of VAD packets (instead of audio packets) will be sent during the period of no talking. If set to “No”, this feature is disabled.

This field contains the number of voice frames to be transmitted in a single packet. When setting this value, the user should be aware of the requested packet time (used in SDP message) as a result of configuring this parameter. This parameter is associated with the first vocoder in the above vocoder Preference List or the actual used payload type negotiated between the 2 conversation parties at run time.

e.g., if the first vocoder is configured as G723 and the “Voice Frames per TX” is set to be 2, then the “ptime” value in the SDP message of an INVITE request will be 60ms because each G723 voice frame contains 30ms of audio. Similarly, if this field is set to be 2 and if the first vocoder chosen is G729 or G711 or G726, then the “ptime” value in the SDP message of an INVITE request will be 20ms.

If the configured voice frames per TX exceeds the maximum allowed value, the IPS-3101h will use and save the maximum allowed value for the corresponding first vocoder choice. The maximum value for PCM is 10(x10ms) frames; for G726, it is 20 (x10ms) frames; for G723, it is 32 (x30ms) frames; for G729/G728, 64 (x10ms) and 64 (x2.5ms) frames respectively.

This field defines the layer 3 QoS parameter which can be the value used for IP Precedence or Diff-Serv or MPLS. Default value is 48.

This contains the value used for layer 2 VLAN tag. Default setting is blank.

18