Remote Controlled TV Functions

1.POWER ON/OFF

Press this button to turn the LCM1042TV on. The channel number or current video source will be displayed on screen, and the picture will appear in a few seconds. Press the button again to turn the LCM1042TV off.

2.DIRECT ACCESS (0-9) BUTTONS

Use these buttons to make a direct channel selection. The channel number chosen will be displayed on the screen for about 4 seconds. To select channels 0-99, press two number buttons. For example, to select channel 8, press 0, 8. To select channels above 100, press the 1-- button, then the number buttons for the last two digits of the channel. For example, to select channel 115, press 1--, 1, 5.

3.CHANNEL UP/DOWN BUTTONS

Use these buttons to advance to the next higher or lower channel.

4.PIX AND VOLUME UP/DOWN BUTTONS

To raise or lower the volume level. Also used to adjust the picture control setting when “contrast”, “bright”, “color” or “tint” is displayed on – screen.

-7-

5.TV / VIDEO BUTTON

Any video equipment connected to the AUDIO/ VIDEO inputs can be used with the TV by pressing this button. Each time the button is pressed, the Audio/Video source will change in the following sequence VIDEO 1, VIDEO 2 and TV.

6.MUTE BUTTON

Press this button to turn TV sound off. Press again to restore sound to the previously set level. Mute may also be released by pressing the VOLUME +/- buttons.

7.SKIP / SEARCH BUTTON

This button selects between SKIP and SEARCH mode. In “SKIP mode” the TV only stops on channels that are programmed into memory when the CHANNEL UP/DOWN buttons are pressed. When SKIP is turned off, the TV will advance to next channel/previous channel number when channel up/down is pressed.

8.ERASE / WRITE BUTTON

When tuned to a channel, press this button to store or erase the channel from memory. The stored channel numbers are displayed in green on the screen, and the non-stored channels are in red.