CHANNEL TUNING SETUP
In order to easily access all available channels, it may be necessary to perform channel auto - programming whenever the vehicle’s geographic location has changed, i.e. city to city, weak signal area.
1.Press the AUTO MEMORY button on the remote control unit. You will see the TV cycle through all it’s channels. The
2.(A) To tune only stored clear channels with the CHANNEL UP/DOWN buttons, press the SKIP/SEARCH button on the Remote Control Unit until “SKIP MODE ON” is displayed on the bottom of the screen. The TV will now tune only to stored channels when the CHANNEL UP/DOWN buttons are used on the monitor or the remote control. (B) To tune to weak or marginal channels with the CHANNEL UP/DOWN buttons, press the SKIP/SEARCH button on the Remote Control Unit until “SKIP MODE OFF” is displayed on the bottom of the screen. Tune to the desired channel using the CHANNEL UP/DOWN buttons or go directly to the channel by using the
3.To ERASE a channel, press the ERASE/ WRITE button on the Remote Control Unit until “MANUAL MEMORY XX ERASE ” is displayed on screen. To STORE a channel, press the button until the MANUAL MEMORY XX ADD is displayed on
screen.
Note: Please refer to page 2 for more information on TV reception.
TURNING THE LCM1042TV ON OR OFF
1.Sliding the screen release lock forward will unlock the LCD screen and it will drop down slightly. (Pivot the screen downward until a comfortable angle is reached).
2.Pressing the power button on the pod or remote will alternately turn the system on or off. When in use the internal back lighting will illuminate the controls. After the unit has been turned on and is displaying a picture, adjustment to the viewing angle can be made by pivoting the screen to optimize the picture quality. The friction hinges will hold the screen in position while the system is in use.
3.Remember to turn the unit off and pivot the LCD to the locked position when not in use.