| TECHNICAL NOTES & SPECIFICATIONS |
|
|
ARCHITECTS SPECIFICATIONS
ming circuit optimized for minimum filter interaction | |
The graphic equalizer shall be monaural (1 channel). | and constant bandwidth at any slider setting. Boost and |
It shall consist of 31 bands centered on standard ISO | cut characteristics shall be fully symmetrical, with the |
frequencies at intervals of 1/3 octave and covering a | filter being electrically removed from the circuit in the |
frequency range of 20Hz to 20kHz. Individual bands | center (flat) position. Individual filters shall be accurate |
shall be activated by linear slide faders with a 25mm | to within 3% of indicated center frequency and shall be |
travel , and a tactile center detent. The range of equal- | |
ization per band shall be either ±6dB or ±15dB selected | The equalizer shall also include an 18dB per octave |
via a | high pass filter at 40Hz, equipped with a bypass switch. |
of unity with all sliders centered, and shall have a maxi- | Green signal presence and red clip indicators shall show |
mum in/out level of +23dBu. Frequency response shall | critical operating levels. Input gain shall be adjustable |
be ±.25dB 20Hz to 20kHz. Hum and noise shall be at | over |
least | switch shall be included. The equalizer shall weigh 6.5 |
THD shall be less than .01% at full output. Input | lbs net and mount in a standard 19 rack using 1 space |
impedance shall be 20k balanced, 10k ohm unbal- | (1.75 high). The power requirement shall be 90- |
anced. Output impedance shall be 200 ohm balanced, | 125VAC, |
100 ohm unbalanced. Inputs and outputs shall be | Audio |
active (tranformerless) balanced type on both XLR, 1/4 |
|
phone jacks and barrier strip terminals. Individual fil- |
|
ters shall be |
|
|
|
Features:
Constant "Q" design for low ripple and minimum interac- tion
Precision Wein Bridge Filters
Balanced XLR, 1/4 TRS & Barrier
Strip Screw Terminals on Inputs and
Outputs
Selectable 15dB or 6dB Range
Switchable 18dB/Octave High Pass Filter
Low Noise Design
Silent In/Out Switching
Signal Present and Clip LEDs
25mm Fader with