Ashly Q-Power Series warranty Specifications

	Gain Setting
	(26 dB, 32 dB, 1,4 V)
Channel A & B output	Input Channel C
Channel C & D output	Input Channel D

MODE L:

OUTPUT PWR PE R CH/IMP:
SER. NO. :	MADE IN GE R MANY

Input Channel B

Input Channel A

	Channel D, C, B & A output (barrier strip)		Input Channel D & C		Input Channel B & A
			Clip Limiter Channel D & C	Clip Limiter Channel B & A
			(Off, On)		(Off, On)
Specifications:		Q-Power 6		Q-Power 10
	16 Ω	470 W		620	W
	8 Ω	800 W		1100	W
Power per channel	4 Ω	1000 W		1800	W
All channels driven	4 Ω Max RMS	1500 W		2500	W
@ 1kHz, THD < 1%
	70 V line operation	950 W		1600	W
100 V line operation		N/A		625	W
	16 Ω	480 W		620	W
Power per channel	8 Ω	960 W		1350	W
Single channel driven	4 Ω	1500 W		2400	W
@ 1kHz, THD < 1%
	4 Ω Max RMS	1600 W		2600	W
No. of channels		4		4
Max. Output Voltage		125Vp / 250Vpp		145Vp / 290Vpp
Output Circuitry		Class H		Class D
Signal To Noise-Ratio		> 115 dB (A-weighted)		> 115 dB (A-weighted)
20 Hz - 20 kHz, 8 Ω load		> 112 dB (unweighted)		> 112 dB (unweighted)
THD+N (typical)		< 0,01 %		< 0,01 %
20 Hz - 20 kHz, 8 Ω load,
6 dB below rated power
SMPTE 4:1 (typical)		< 0,01 %		< 0,02 %
60 Hz + 7kHz, 8 Ω load
8 dB below rated power
Damping Factor		> 350		> 600
8 Ω load, 1 kHz and below
Net Weight		10,6 kg / 23,4 lbs		11,5 kg / 25,4 lbs
Shipping Weight		12,6 kg / 27,8 lbs		13,5 kg / 29,8 lbs
Frequency Response		20 Hz - 20 kHz ± 0,15 dB
8 Ω load, 1 dB below rated power
Input Impedance		15 kΩ balanced
Input Gain		selectable: 26 dB, 32 dB or 1,4 V input sensitivity
		inrush-current limitation, protection circuits against power on/off transients, temperature monitoring of
Protection Circuits		transformers and heat-sinks, output DC protection, power transistor control, temperature dependent SOA
		protection, intelligent mains fuse protection
Limiter		two switchable peak-limiter for channel A+B and C+D respectively
Fan		2 temperature dependent speed-controlled axial fans
Indicators		LED’s for ON, SIGNAL/PROTECT, CLIP, Output Current
Input Connectors		3-pin XLR, male and female per channel, pin 2 = in phase / Phoenix Connectors, pin 1 = in phase, pin 2 = GND
Output Connectors		Two 4-pole SPEAKON connectors / Barrier Strip with protection cover
Operation Voltage		Dual Voltage SMPS with automatic voltage selection for 120 V / 230 V operation
Dimensions (WxHxD)		483 x 88,9 x 419 mm / 19 x 3,5 x 16,5 inches (19”, 2U)
Shipping Dim. (WxHxD)		600 x 105 x 527 mm / 23,3 x 4,1 x 20,7 inches
Accessories included		Gain pot security cover

Specifications subject to technical alterations without prior notice.

www.camcoaudio.com