Multiquip manual HTH44T- Specifications, HTH-44T Specifications

HTH44T— SPECIFICATIONS

Figure 1. HTH44T Dimension /Specifications

Table 2. HTH-44T Specifications

A–Length – in. (cm)	96.00 (243.8)
B–Width – in. (cm)	50.0 (127)
C–Height – in. (cm)1	56.0 (142)
Weight – lbs. (kgs.) Operating	1,545	(700)
Weight – lbs. (kgs.) Shipping	1,848	(838)
Sound Pressure – dBA2	TBA
Vibration – ft/s2 (m/ s2)3	TBA
Blade Tip Speed – FPM (m/s)	1924	(9.9)
Engine – H.P.	44
Fuel Tank – gallons (liters)	12 (45)
Rotor – RPM	0 to 160
Path Width – in. (cm)	92 (233)
Hydraulic Oil4	AW MV 68
Engine	Kubota Diesel V1505-TE

NOTE:

1.This value includes the seat height.

2.Sound pressure is a weighted measure. Measured at the operators ear position while the ride-on trowel is operating at full throttle on concrete in a manner most often experienced in “normal” circumstances. Sound pressure may vary depending upon the condition of the concrete. Hearing protection is always recommended.

3.The vibration level indicated is the maximum RMS (Root Mean Square) value obtained at the handle grip while operating the ride-on trowel on curing concrete in a

manner

most often experienced in “normal” circumstances. Values were obtained from all three axes of motion. The values shown represent the maximum RMS value from these measurements.

4.“AW” stands for anti-wearand “MV” stands for multi- viscosity. The 68 refers to the general viscosity range and is similar to 10W-30-motor oil. It is recommended that AW MV 68 hydraulic oil be used. If this type of hydraulic oil is not available then use 10W-30.

PAGE 12 — HTH44T • RIDE-ON POWER TROWEL — OPERATION AND PARTS MANUAL — REV. #8 (03/27/12)