Multiquip HTH44T manual Wiring?

		HTH44T—TROUBLESHOOTING
	TABLE 4. TROUBLESHOOTING (CONTINUED)
SYMPTOM	POSSIBLE PROBLEM	SOLUTION
		Check all electrical connections, including the master on/off switch
	Wiring?	and check to see if wiring is in good condition with no shorts.
		Replace as necessary.
Lights (optional) not working.
	Lights?	Check to see if light bulbs are still good. Replace if broken.
		Check the tank to make sure retardant is present. Fill tank as
	Retardant?	necessary.
		Check all electrical connections, including master on/off switch
	Wiring?	connections. Replace components and wiring as necessary.
Retardant spray (optional) not
working.	Bad switch?	Check the continuity of master on/off switch. Replace if broken.
		If pump has a voltage present when the switch is turned on, but
	Bad spray pump?	does not operate and electrical connections to the pump are
		good, replace the pump.
	Blade speed out of adjustment?	See section on blade speed adjustment.
		Check for wear of steering bearings and linkage components
	Worn components?	replace if necessary.
Steering is unresponsive.
	Pivots?	Check to ensure free movement of hydraulic drive motors.
		Check to ensure that hydraulic pressure is adequate. See section
	Hydraulic pressure?	on checking hydraulic pressure.
Operating position is	Seat adjust for operator?	Adjust seat with lever located on the front of the seat.
uncomfortable.
		Make sure that both crank handles are pushed down as far as
Linkage on Twin Pitch (optional)	Crank handles?	possible. Doing this ensures that the linkage is engaged.
not working.
	Broken part?	Replace all broken parts immediately.

HTH44T • RIDE-ON POWER TROWEL — OPERATION & PARTS MANUAL — REV. #8 (03/27/12) — PAGE 27