HTH44T— CONTROLS AND INDICATORS

Figure 3. HTH44T Controls and Indicators (Rear)

23.Lift Loops Located on both the left and right sides of the main frame. Used when the trowel must be lifted onto a concrete slab.

24.Engine Oil Dipstick – Indicates engine oil level.

25.Engine Oil Filler Cap - Remove this cap to add engine oil.

26.Air Filter – Prevents dirt and other debris from entering the fuel system.

27.Oil Filter – Provides oil filtering for the engine.

28.Retardant Spray Motor – Used with the spray control button.

NOTE

Read this entire instruction manual

Specification and part number completely before attempting to operate this are subject to change without

machine. notice.

29.Retardant Spray Tank - Holds 5 gallons of retardant or water.

30.Battery - Provides +12V DC power to the electrical system.

31.Hydraulic Suction Filter - Filters hydraulic fluid prior to entering the system.

32.Hydraulic Return Filter - Filters hydraulic returning to reservoir.

33.Documentation Box - Contains information regarding the trowel.

NOTE

The following section is intended as a basic guide to the Ride-On Power Trowel operation, and is not to be considered a complete guide to concrete finishing. It is strongly suggested that all operators (experienced and novice) read “Slabs on Grade” published by the American Concrete Institute, Detroit Michigan.

HTH44T • RIDE-ON POWER TROWEL — OPERATION & PARTS MANUAL — REV. #8 (03/27/12) — PAGE 15

Page 15
Image 15
Multiquip manual HTH44T Controls and Indicators Rear