OPTIONS, CONTINUED
Drying
This lets you select how long the turbo fan runs after the final rinse. You have three options: Short, Normal, or Extra drying. (Note: This option is not available with the Auto wash, Rinse and Hold, and Rinse and Dry programs.) To set the drying time, press Menu until “Drying” displays, then press Set until your preference displays.
Express
This option reduces the wash time and lowers the wash temperature by 20° F. (Note: This option is not available with the Quick Wash and Rinse and Hold/Dry Programs.) Press Menu until Express displays, then press Set once to select On or twice to select Off. Press Menu to confirm your selection.
Cool Touch
This option lets you set a
PROGRAM TIMES
The program times may not always be the same because of variations in the household hot water temperature. The dishwasher heats the water to the proper temperature for the program selected; so if the temperature of the water entering the dishwasher is too low, the dishwasher will run longer because it takes longer to heat the water. Raising your water heater setting could help to shorten the cycle times.
INTERRUPTING A PROGRAM TO ADD AN ITEM
If you want to interrupt a program to add an item, open the door slightly until the spray arms stop turning. You can then open the door fully and place the item into the dishwasher. Close the door securely. The program will continue from where it was interrupted.
WARNING! Be extremely careful when opening the door during a program. The water is hot and you could get scalded.
START/STOP BUTTON
Once you have selected the wash program and options, press this button to start the dishwasher. (Make sure the door is securely closed.)
CHANGING OR STOPPING A PROGRAM
If you decide to change the program after you have started the machine, press the Start/Stop button for three seconds. You will have to select the program and options again when you are ready to restart the program. (Note: If the program has already gone through the wash cycle, you will have to add detergent.)
FAULT CODES
In the event that the machine should fail during a program, the display window will show a fault code. The table below defines these codes and gives possible causes and solutions. See also “Troubleshooting” on page 13.
If you have corrected the fault, turn the main power off then back on to remove the fault indication. If it still displays, try again to correct the problem or call a service technician.
Display | Type of Fault and Recommended Action |
Overfilling | Too much water has entered the dishwasher. Call a service technician. |
Water Inlet Fault | Water inlet fault. Make sure the water supply is open. |
Inlet Valve Leakage | Valve leakage. Shut off the water supply and contact a service technician. |
Drainage | The drain is blocked. See “Troubleshooting” on page 13. |
Blocked Filter | The filter is clogged. See “Cleaning the Filters” on page 10. |
Page 8
