Aspire Digital RFKGT manual

3

Red Light

Program

Button

Program

Button

Program

Button

Program

Button

Transmitter

Buttons

Programming To Operate

NOTE: Any of the three transmitter buttons can be programmed to activate the door. In multi-door installations, each button can be programmed to activate a separate door. Only one button at a time (per-transmitter) can be programmed to activate a door.

To program the transmitter:

1. Place the emergency disconnect handle in the manual door operated position. This is for safety reasons.

2. Press program button on Wayne Dalton DoorMaster™ light fixture, idrive®, prodrive™, Quantum™ or Classicdrive™ operator. LED will light or idrive® operator will beep once indicating that it is ready to learn a

transmitter.

3. Within 30 seconds, press and hold the desired transmitter button(s);

LED will turn off or idrive® operator will beep once. On the DoorMaster™

only, release the transmitter button and press again. LED will light briefly

then turn off.

4. Return the emergency disconnect handle to motor operated

position.

5. Press same transmitter button(s) again; door should operate.

Transmitter is now programmed to operator.

6. To OPERATE, press the transmitter button.

NOTE: idrive® model only: The first transmitter command after

programming will only open the door through a six inch up/down cycle. Normal door operation will then occur on all subsequent transmitter

commands.

Glossary

Copy – See Replicate.

Delete – Erase transmitter or SCENE information from Controller. Also known as Exclude. Device – Any item that is connected to a module (for example, lamps).

Exclude – Remove a module from the controller. Include – Add a module to the controller.

– Any ASPIRE RF or Z-Wave™ product that is controlled with a ASPIRE RF or Z-Wave™ remote controllerModule . A module can be part of more than one scene.

– A collection of devices controlled by primary or secondary controllers operating on the same systemNe work. A network has its own unique identification code so that no one else can control the system. Operator – Garage Door Opener

– The first controller used to set up your modules and network. NOTE: Only the Primary ControllerPrimary Controllercan be used to include or delete modules from a network. It is recommended that you mark the primary controller for ease in modifying your network.

Replicate – Copy from one controller to another.

– A scene is a series of Z-Wave™ devices programmed to turn to a specific level (on, off, dim) with thepushSc ne of a button on a controller.

– A controller containing network information about other modules within the network,S condaryandControlleris created FROM the primary controller. Secondary controllers cannot include or delete modules to the network.

Transmitter – Garage Door Opener transmitter.