Examples Of Scenes
2. In your car and leaving your home you wish to turn off the outside lights near the garage, front door and rear door, as well as interior lights and appliances. Wireless Gateway SCENE 2 can be programmed to turn all of these modules OFF and to turn ON the security alarm. To operate SCENE 2 from your car, you will also need to program one button of the remote located in your car to SCENE 2.
3. Noises outside your home awaken you during the night. SCENE 3 is programmed to turn on only the outside lights. You can turn on SCENE 3 with your Keychain Remote from your bedroom to illuminate the area and scaring off any potential intruders.
4. Lights out! You have tucked your 2 children in bed and one has your permission to read for 15 minutes while the other has your permission to watch TV for 15 minutes. After 15 minutes you want to turn off their lights and TV. SCENE 2 is programmed to their bedroom lights, lamps and to a TV in the childs room. Using your Keychain Remote you can turn their lights and TV off.
1 - Wireless Gateway, RFBGD
1 - Keychain Remote, (RFKGT) or any
3 - Dimmer Switch, RF9534 (for each light switch)
2 - Lamp Module, RFLDM
(for lamp in kitchen and family room)
1 - Wireless Gateway, RFBGD
1 - Keychain Remote, RFKGT
3 - Dimmer Switch, RF9534 (for each light switch)
2 - Switches, RF9501 (for exterior lights)
1 - Wireless Gateway, RFBGD
1 - Keychain Remote, RFKGT
2 - Dimmer Switch, RF9534 (for each light switch)
2 - Lamp Module, RFLDM
(for lamp in kitchen and family room) 1 - Appliance Module, RFAPM (for the TV)
Button Combinations
Press two transmitter
buttons at the same time
Use this procedure to program your Keychain Remote for up to 6 actions. In any of the previous programming instructions at the point where you need to activate a transmitter button to complete the programming step, simply simultaneously press a combination of any two buttons. Then to activate that programmed action, simultaneously press those two buttons.
Example of Use: Single Big button is programmed only to activate Garage Door Opener, while each of the two smaller buttons are programmed to SCENE 1 and 2 of the Gateway Module. SCENE 3 of the Gateway module can be programmed to activate by pressing the two smaller buttons at the same time.
Troubleshooting
Problem:
The range of the transmitter is reduced.
Problem:
The LED (light) on the transmitter does not turn on when pressed.
Solution:
Replace Battery.
Solution: | Coin Slot |
To change the batteries, | |
insert a coin in the coin |
|
slot and twist to access |
|
the battery compartment. |
|
Your transmitter may use |
|
one or two CR2016 |
|
batteries. Remove the |
|
batteries from the battery |
|
cage and replace with fresh batteries. |
|
Be sure to maintain the correct polarity (+). |
|
5