PLED (System Power LED):

Connect to the power status indicator on the chassis front panel. The LED is on when the system is operating. The LED keeps blinking when the sys- tem is in S1 sleep state. The LED is off when the system is in S3/S4 sleep state or powered off (S5).

HDLED (Hard Drive Activity LED):

Connect to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive is reading or writing data.

The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin assign-ments are matched correctly.

Chassis Speaker Header

Please connect the chassis

(4-pin SPEAKER 1)

speaker to this header.

(see p.13 No. 8)

 

Chassis and Power Fan Connectors

(4-pin CHA_FAN1)

CHA_FAN_SPEED

(see p.13

No. 12)

+12V

FAN_SPEED_CONTROL

GND

 

(3-pin PWR_FAN1)

 

GND

(see p.13

No. 1)

 

+12V

PWR_FAN_SPEED

Please connect the fan cables to the fan connectors and match the black wire to the ground pin.

CPU Fan Connector

4 3 2 1

(4-pin CPU_FAN1)

 

(see p.13 No. 4)

GND

 

+12V

 

CPU_FAN_SPEED

 

FAN_SPEED_CONTROL

Please connect the CPU fan cable to the connector and match the black wire to the ground pin.

Though this motherboard provides 4-Pin CPU fan (Quiet Fan) support, the 3-Pin CPU fan still can work successfully even without the fan speed control function. If you plan to connect the 3-Pin CPU fan to the CPU fan connector on this motherboard, please connect it to Pin 1-3.

Pin 1-3 Connected

3-Pin Fan Installation

29

Page 29
Image 29
ASRock H61M-DPS manual Chassis Speaker Header