![](/images/new-backgrounds/1284612/28461221x1.webp)
is on when the system is operating. The LED keeps blinking when the sys- tem is in S1 sleep state. The LED is off when the system is in S3/S4 sleep state or powered off (S5).
HDLED (Hard Drive Activity LED):
Connect to the hard drive activity LED on the chassis front panel. The LED is on when the hard drive is reading or writing data.
The front panel design may differ by chassis. A front panel module mainly consists of power switch, reset switch, power LED, hard drive activity LED, speaker and etc. When connecting your chassis front panel module to this header, make sure the wire assignments and the pin
Power LED Header
1 |
|
|
|
|
|
| |
|
|
|
|
| PLED- | ||
(see p.2 No. 11) |
|
|
| PLED+ | |||
PLED+ |
Please connect the chassis power LED to this header to indicate system power status. The LED is on when the system is operating. The LED keeps blinking in S1 state. The LED is off in S3/S4 state or S5 state (power off).
Chassis Fan Connector |
|
| Please connect the fan cables |
|
| to the fan connectors and | |
(see p.2 No. 13) |
|
| match the black wire to the |
|
|
| ground pin. |
|
|
|
|
CPU Fan Connectors |
|
| Please connect the CPU fan |
1 | GND | cable to the connector and | |
(see p.2 No. 19) | 2 | +12V | match the black wire to the |
3 | CPU_FAN_SPEED | ||
| 4 | FAN_SPEED_CONTROL | ground pin. |
|
|
|
Though this motherboard provides
Pin
11
English
ASRock