Associated Equipment manual To Charge Batteries, END of Charge, Model 6065 Parts List

TO CHARGE BATTERIES:

This charger is designed to charge all types of 12 volt automotive batteries. The voltmeter scale is color coded to represent the three most common types of batteries.

The GREEN scale represents the proper voltages for CONVENTIONAL batteries.

The BLUE scale represents the proper charging voltages for RECOMBINATION batteries and LOW MAINTENANCE batteries. The YELLOW scale represents the proper charging voltage for MAINTENANCE FREE batteries.

The RED scale areas indicate the charging voltage is too high and should be turned down, If not turned down, over charging can occur to the batteries.

A CONVENTIONAL battery is one that has accessible filler caps and the plates are lead-antimony construction. A RECOMBINATION battery is one that has no filler caps and no free electrolyte.

A LOW MAINTENANCE battery is one that has filler caps and the plates are a combination of lead-antimony and lead-calcium. A MAINTENANCE FREE battery may or may not have filler caps and the plates are lead-calcium.

If more than one type of battery is charged at one time, use the lowest suggested settings.

To charge batteries overnight: Adjust charging voltage to 3/4-1 volt less than the recommended highest voltage. Do not exceed 30 amps. As the batteries charge, the charging current will decrease and the charging voltage increase. The “end of charge” voltage should not exceed the maximum suggested value.

The charging voltage bands are intended to be guidelines to enable the operator to have a starting point to charge batteries. The age of the batteries, temperature, and type of batteries will affect the charging cycle. The best setting for your charging conditions will have to be determined by experience.

END OF CHARGE:

Discontinue charging when specific gravity reading does not change in 3 consecutive readings, battery is freely gassing or when the electrolyte reaches 120˚F. If your battery is sealed and these determinations cannot be made, see manufacturers instructions for charging.

		MODEL 6065 PARTS LIST
605675	Switch w/knob (1)	610057	Handle (Optional Accessory)
605632	Ammeter	610253	Side Panels (1 Pr.)
610058	Voltmeter	610075	Top Panel
605206	A.C. Cord	610076	Base
605628	D.C. Cable Set	610081	Front Panel
610122	Rectifier Assembly	610082	Back Panel
610069	Circuit Breaker	610097	Transformer -

If you elect to order parts from the factory you may do so by mail or phone. Minimum order from the factory is $25.00. Orders received that are under the minimum will not be processed. Taxes and freight are extra and are not considered to be part of the dollar value of the order. We do not have a COD. policy. Cashier check, money order, Master Card or Visa are acceptable. If you use a Master Card or Visa Card send only the number and expiration. Do not send the card.

ASSOCIATED EQUIPMENT CORP.

5110 Brown, St. Louis, Mo. 63115

Phone (314) 385-5178

027-0017

ECN 1712

Rev. 11/87