Rear Panel
English
Power connector | Fans |
Connecting network devices
To connect network devices to the switch:
1.Connect one end of an Ethernet cable to an Ethernet port on the front panel of the switch. Connect the other end to the Ethernet port of the network device. Repeat this step to connect other network devices.
NOTES
•Use only Category 5 Ethernet cables to ensure proper connections between the switch and other network devices.
•You may use the ports on the switch to uplink to another switch, hub, bridge, or repeater as an uplink port using either crossover or
The MDI/MDIX feature of the switch allows automatic detection of the type of cables connected to it, and adjustment to the appropriate MDI or MDIX setting for each cable.
2.Plug one end of the power cable to the power connector on the switch rear panel, then plug the other end to an electrical outlet.
The Power LED and the LED indicators for active Ethernet ports light up to indicate that the device is on and in use. Refer to the front panel LED table on page 4 for the LED descriptions.
6 | ASUS GigaX 1124 |