Asus 7700 2.1Preparation, 2.2Removing the side panel, Basic components to install, Tool

1 28

You need to install the following components to the VENTO 7700 chassis kit.

1.Motherboard

2.Power supply unit (PSU)

3.Hard disk drive (s)

4.5.25-inch drive(s)

5.Floppy disk drive(s)

6.Expansion card(s)

You need a flat screw driver to remove the slot covers.

To remove the side panel:

1.Locate the two thumbscrews on the rear panel.

2.Turn each thumbscrew counterclockwise to release the side panel from the chassis.

The thumbscrews do not completely disengage from the side plate.

2 - 2

Chapter 2: Basic installation

Contents

Page E2539 Revised Edition March Contents Chapter 1: Product introduction Chapter 2: Basic installation Notices Federal Communications Commission Statement Canadian Department of Communications Statement Safety information Electrical safety Operation safety About this guide How this guide is organized Where to find more information Conventions Page 1.1Welcome 1.2Package contents 1.3System specifications 1.4Exploded drawing 1.5Internal features Page 2.1Preparation Basic components to install Tool 2.2Removing the side panel Page 2.3Installing the power supply unit (PSU) Voltage selector 2.4Installing the motherboard 2.5Installing a hard disk drive 2.5.1Installing an IDE hard disk drive Page 2.5.2Installing a Serial ATA hard disk drive 2.6Installing a 5.25-inchdrive Page Page 2.7Installing a 3.5-inchfloppy disk drive Page 2.8Installing expansion cards Page 2.9Replacing the side panel ASUS contact information ASUSTeK COMPUTER INC. (Taiwan) ASUSTeK COMPUTER INC. (Asia-Pacific) ASUS COMPUTER INTERNATIONAL (America) ASUS COMPUTER GmbH (Germany/Austria)