5.Carefully insert the floppy disk drive into the bay, then push it inward until it is completely flushed into the chassis.

6.Make sure that the FDD screw holes are aligned with the FDD bay screw holes.

7.Press down the drive bay lock to secure the floppy disk drive to the chassis.

8.Connect an FDD signal cable to the FDD connector at the back of the drive then connect

the other end to the FDD

connector on the9

motherboard.8

Refer to the motherboard user guide for the location of the FDD connector.

9.Connect a 4-pin power plug from the power supply unit to the power connector at the back of the drive.

2 - 14

Chapter 2: Basic installation