Asus A7VL133-VM 16)USB Header (10-1pin USB2), ASUS A7VL133-VMUser’s Manual, 17)ATX Power Supply Connector (20 pin block ATXPWR)

3.HARDWARE SETUP

16)USB Header (10-1 pin USB2)

If the USB port connectors on the back panel are inadequate, this USB header is available for two additional USB port connectors. Connect the USB headers to the 2-port USB connector set and mount the bracket to an open slot on your chassis.

USB2	Power USB
–USBP3 USBP3+ GND
10	6
5	1
–USBP2 USBP2+ GND NC	PowerUSB
A7VL133-VM

A7VL133-VM USB Port

17)ATX Power Supply Connector (20 pin block ATXPWR)

This connector connects to an ATX power supply. The plug from the power sup- ply will only insert in one orientation because of the different hole sizes. Find the proper orientation and push down firmly making sure that the pins are aligned.

IMPORTANT: Make sure that your ATX power supply can supply at least 10mA on the +5-volt standby lead (+5VSB). You may experience difficulty in powering ON your system if your power supply cannot support the load. For Wake- On-LAN support, your ATX power supply must supply at least 720mA +5VSB.

	+3.3		Volts	+3.3 Volts
		-12.0 Volts		+3.3 Volts
		Ground		Ground
		Power Supply On		+5.0 Volts
		Ground		Ground
		Ground		+5.0 Volts
		Ground		Ground
	-5.0		Volts	Power Good
	+5.0		Volts	+5V Standby
	+5.0		Volts	+12.0 Volts
A7VL133-VM

A7VL133-VM ATX Power Connector

.3 SETUPH/W

Connectors

ASUS A7VL133-VM User’s Manual 35