3. HARDWARE SETUP

The following HPANEL illustration is used for items 19–23:

 

HPANEL

 

 

 

 

Speaker

 

 

 

Connector

Power LED

 

Ground Ground

 

+5 V

PLED

+5V

SPKR

 

ExtSMI# Ground

PWR SW Ground

ResetCon

Ground

A7VL133-VM

 

 

Reset SW

SMI Lead

ATX Power Switch*

A7VL133-VM System Panel Connectors* Requires an ATX power supply.

19)System Warning Speaker Connector (4-pin SPEAKER)

This 4-pin connector connects to the case-mounted speaker. Two sources (LINE_OUT and SPEAKER) will allow you to hear system beeps and warn- ings. Only SPEAKER will allow you to hear system beeps before the integrated audio has been properly initialized.

20)System Power LED Lead (3-1 pin PWR.LED)

This 3-1 pin connector connects the system power LED, which lights when the system is powered on and blinks when it is in sleep mode.

21)Reset Switch Lead (2-pin RESET)

This 2-pin connector connects to the case-mounted reset switch for rebooting your computer without having to turn off your power switch. This is a preferred method of rebooting to prolong the life of the system’s power supply.

22)ATX Power Switch Lead (2-pin PWR.SW)

The system power is controlled by a momentary switch connected to this lead. Pressing the button once will switch the system between ON and SOFT OFF. Pushing the switch while in the ON mode for more than 4 seconds will turn the system off. The system power LED shows the status of the system’s power.

23)System Management Interrupt Lead (2-pin SMI)

This allows the user to manually place the system into a suspend mode or “Green” mode, where system activity is decreased to save electricity and expand the life of certain components when the system is not in use. This 2-pin connector con- nects to the case-mounted suspend switch. If you do not have a switch for the connector, you may use the “Turbo Switch.” SMI is activated when it detects a short to open moment and therefore leaving it shorted will not cause any prob- lems. This may require one or two presses depending on the position of the switch. Wake-up can be controlled by settings in the BIOS but the keyboard will always allow wake-up (the SMI lead cannot wake up the system).

.3 SETUPH/W

Connectors

ASUS A7VL133-VM User’s Manual

37